Analyze

1D Plots 2D Images Original Inputs Timing Output Warnings

1D Plots

2D Images

Table of Original Inputs

All inputs used for the calculation

Value
Target Mag 6.776
Saturation Level (electons) 72.0
Instrument niriss
Mode soss
Aperture soss
Disperser gr700xd
Subarray substrip96
Readmode nisrapid
Filter clear
Primary/Secondary rp^2/r*^2

Timing Info

All the timing info needed for your observation. Overhead calculation assumes 30 minute target acquisition time.

Value
Transit Duration 3.600000
Seconds per Frame 2.214000
Time/Integration incl reset (sec) 66422.214000
APT: Num Groups per Integration 30000.000000
Num Integrations Out of Transit 1.000000
Num Integrations In Transit 1.000000
APT: Num Integrations per Occultation 2.000000
Observing Efficiency (%) 99.993334
Transit+Baseline, no overhead (hrs) 36.901230
Number of Transits 14.000000

Warnings

Pay attention to these warnings! If you do not see 'All good' written in each box, reconsider your run.

Value
Group Number Too Low? All good
Group Number Too High? All good
Non linear? Partial saturation:\n There are 201667 pixels saturated at the end of a ramp. Partial ramps may still be used in some cases.
Saturated? Full saturation:\n There are 6010 pixels saturated at the end of the first group. These pixels cannot be recovered.
% full well high? All good
Num Groups Reset? All good

References

When publishing results based on PandExo, please cite:

Batalha, N.E., Mandell, A., Pontoppidan,K., et al., 2017, PASP, 129, 976

Download Data