Navigate
Edit DashboardAnalyze
1D Plots 2D Images Original Inputs Timing Output Warnings1D Plots
2D Images
Table of Original Inputs
All inputs used for the calculation
| Value | |
|---|---|
| Target Mag | 10.0 |
| Saturation Level (electons) | 116193.0 |
| Instrument | miri |
| Mode | lrsslitless |
| Aperture | imager |
| Disperser | p750l |
| Subarray | slitlessprism_ip |
| Readmode | fastr1 |
| Filter | None |
| Primary/Secondary | fp/f* |
Timing Info
All the timing info needed for your observation. Overhead calculation assumes 30 minute target acquisition time.
APT Inputs
| Value | |
|---|---|
| Instrument | MIRI |
| Template | MIRI Low Resolution Spectroscopy |
| Subarray | SLITLESSPRISM_IP |
| Dither | None |
| Readout Pattern | FASTR1 |
| Groups per Integration | 32 |
| Exposures/Dith | 1 |
| Integrations/Exp | 980 |
Calculation Details
| Value | |
|---|---|
| Transit Duration (hr) | 0.700000 |
| Number of Transits | 1 |
| Transit + Baseline, No Overhead (hr) | 1.402837 |
| Observing Efficiency (%) | 93.939394 |
| Frame Time (sec) | 0.156160 |
| Integrations In Transit | 490 |
| Integrations Out of Transit | 490 |
| Elapsed Time per Integration incl. Reset (sec) | 5.153280 |
| Science Time per Integration excl. Reset (sec) | 4.840960 |
Warnings
Pay attention to these warnings! If you do not see 'All good' written in each box, reconsider your run.
| Value | |
|---|---|
| Group Number Too Low? | All good |
| Group Number Too High? | All good |
| Non linear? | All good |
| Saturated? | All good |
| % full well high? | All good (60% < 60%) |
| Num Groups Reset? | All good |
| Minimum Integrations? | All good |
References
When publishing results based on PandExo, please cite:
Batalha, N.E., Mandell, A., Pontoppidan,K., et al., 2017, PASP, 129, 976
