Navigate
Edit DashboardAnalyze
1D Plots 2D Images Original Inputs Timing Output Warnings1D Plots
2D Images
Table of Original Inputs
All inputs used for the calculation
| Value | |
|---|---|
| Target Mag | 10.0 |
| Saturation Level (electons) | 52000.0 |
| Instrument | nirspec |
| Mode | bots |
| Aperture | s1600a1 |
| Disperser | prism |
| Subarray | sub2048 |
| Readmode | nrsrapid |
| Filter | clear |
| Primary/Secondary | rp^2/r*^2 |
Timing Info
All the timing info needed for your observation. Overhead calculation assumes 30 minute target acquisition time.
APT Inputs
| Value | |
|---|---|
| Instrument | NIRSpec |
| Template | NIRSpec Bright Object Time Series |
| Subarray | SUB2048 |
| Grating/Filter | PRISM/CLEAR |
| Readout Pattern | NRSRAPID |
| Groups per Integration | 1 |
| Exposures/Dith | 1 |
| Integrations/Exp | 11974 |
Calculation Details
| Value | |
|---|---|
| Transit Duration (hr) | 3 |
| Number of Transits | 1 |
| Transit + Baseline, No Overhead (hr) | 6.000304 |
| Observing Efficiency (%) | 50 |
| Frame Time (sec) | 0.902000 |
| Integrations In Transit | 5987 |
| Integrations Out of Transit | 5987 |
| Elapsed Time per Integration incl. Reset (sec) | 1.804000 |
| Science Time per Integration excl. Reset (sec) | 0.902000 |
Warnings
Pay attention to these warnings! If you do not see 'All good' written in each box, reconsider your run.
| Value | |
|---|---|
| Group Number Too Low? | All good. Ngroups=1 is a new mode since Cycle 4 and has not been rigorously tested. Proceed with caution. |
| Group Number Too High? | All good |
| Non linear? | All good |
| Saturated? | Full saturation: There are 136 pixels saturated at the end of the first group. These pixels cannot be recovered. |
| % full well high? | % full well>80% (473% > 80%) |
| Num Groups Reset? | Optimized NGROUPS below minimum (1). SET TO NGROUPS=1 |
| Minimum Integrations? | All good |
References
When publishing results based on PandExo, please cite:
Batalha, N.E., Mandell, A., Pontoppidan,K., et al., 2017, PASP, 129, 976
