All inputs used for the calculation
| Value | |
|---|---|
| Target Mag | 10.0 |
| Saturation Level (electons) | 52000.0 |
| Instrument | nirspec |
| Mode | bots |
| Aperture | s1600a1 |
| Disperser | prism |
| Subarray | s128m4_prm |
| Readmode | nrsrapid |
| Filter | clear |
| Primary/Secondary | rp^2/r*^2 |
All the timing info needed for your observation. Overhead calculation assumes 30 minute target acquisition time.
| Value | |
|---|---|
| Instrument | NIRSpec |
| Template | NIRSpec Bright Object Time Series |
| Subarray | SUB128M4_PRISM |
| Grating/Filter | PRISM/CLEAR |
| Readout Pattern | NRSRAPID |
| Groups per Integration | 2 |
| Exposures/Dith | 2 |
| Integrations/Exp | 44984 |
| Value | |
|---|---|
| Transit Duration (hr) | 2.400000 |
| Number of Transits | 1 |
| Transit + Baseline, No Overhead (hr) | 4.800293 |
| Observing Efficiency (%) | 7.444815 |
| Frame Time (sec) | 0.057200 |
| Integrations In Transit | 11246 |
| Integrations Out of Transit | 11246 |
| Number of Stripes | 4 |
| Elapsed Time per Full Multistripe Cycle incl. Reset (sec) | 0.768320 |
| Elapsed Time per APT Stripe Integration incl. Reset (sec) | 0.192080 |
| Science Time per Full Multistripe Cycle excl. Reset (sec) | 0.228800 |
| Science Time per Stripe excl. Reset (sec) | 0.057200 |
Pay attention to these warnings! If you do not see 'All good' written in each box, reconsider your run.
| Value | |
|---|---|
| Group Number Too Low? | All good |
| Group Number Too High? | All good |
| Non linear? | All good |
| Saturated? | All good |
| % full well high? | All good (60% < 80%) |
| Num Groups Reset? | All good |
| Minimum Integrations? | All good |
| Exposure Duration? | APT will warn that the exposure duration exceeds 10,000 seconds. NIRSpec BOTS permits longer exposures, but a high-gain antenna repoint may cause an approximately 60-second flux excursion. |
When publishing results based on PandExo, please cite:
Batalha, N.E., Mandell, A., Pontoppidan,K., et al., 2017, PASP, 129, 976