Navigate
Edit DashboardAnalyze
1D Plots 2D Images Original Inputs Timing Output Warnings1D Plots
2D Images
Table of Original Inputs
All inputs used for the calculation
| Value | |
|---|---|
| Target Mag | 7.294 |
| Saturation Level (electons) | 58500.0 |
| Instrument | nirspec |
| Mode | bots |
| Aperture | s1600a1 |
| Disperser | g395h |
| Subarray | sub2048 |
| Readmode | nrsrapid |
| Filter | f290lp |
| Primary/Secondary | rp^2/r*^2 |
Timing Info
All the timing info needed for your observation. Overhead calculation assumes 30 minute target acquisition time.
| Value | |
|---|---|
| Transit Duration | 0.50420 |
| Seconds per Frame | 0.90200 |
| Time/Integration incl reset (sec) | 3.60800 |
| APT: Num Groups per Integration | 3.00000 |
| Num Integrations Out of Transit | 504.00000 |
| Num Integrations In Transit | 504.00000 |
| APT: Num Integrations per Occultation | 1008.00000 |
| Observing Efficiency (%) | 50.00000 |
| Transit+Baseline, no overhead (hrs) | 1.01024 |
| Number of Transits | 1.00000 |
Warnings
Pay attention to these warnings! If you do not see 'All good' written in each box, reconsider your run.
| Value | |
|---|---|
| Group Number Too Low? | All good |
| Group Number Too High? | All good |
| Non linear? | Partial saturation:\n There are 1214 pixels saturated at the end of a ramp. Partial ramps may still be used in some cases. |
| Saturated? | All good |
| % full well high? | % full well>80% |
| Num Groups Reset? | All good |
References
When publishing results based on PandExo, please cite:
Batalha, N.E., Mandell, A., Pontoppidan,K., et al., 2017, PASP, 129, 976
