Analyze
1D Plots 2D Images Original Inputs Timing Output Warnings1D Plots
2D Images
Table of Original Inputs
All inputs used for the calculation
| Value | |
|---|---|
| Target Mag | 8.587 |
| Saturation Level (electons) | 57600.0 |
| Instrument | niriss |
| Mode | soss |
| Aperture | soss |
| Disperser | gr700xd |
| Subarray | substrip256 |
| Readmode | nisrapid |
| Filter | clear |
| Primary/Secondary | rp^2/r*^2 |
Timing Info
All the timing info needed for your observation. Overhead calculation assumes 30 minute target acquisition time.
| Value | |
|---|---|
| Transit Duration | 4.850000 |
| Seconds per Frame | 5.494000 |
| Time/Integration incl reset (sec) | 10.988000 |
| APT: Num Groups per Integration | 1.000000 |
| Num Integrations Out of Transit | 1590.000000 |
| Num Integrations In Transit | 1590.000000 |
| APT: Num Integrations per Occultation | 3180.000000 |
| Observing Efficiency (%) | 50.000000 |
| Transit+Baseline, no overhead (hrs) | 9.706067 |
| Number of Transits | 1.000000 |
Warnings
Pay attention to these warnings! If you do not see 'All good' written in each box, reconsider your run.
| Value | |
|---|---|
| Group Number Too Low? | All good. Ngroups=1 is a new mode since Cycle 4 and has not been rigorously tested. Proceed with caution. |
| Group Number Too High? | All good |
| Non linear? | All good |
| Saturated? | All good |
| % full well high? | All good |
| Num Groups Reset? | All good |
References
When publishing results based on PandExo, please cite:
Batalha, N.E., Mandell, A., Pontoppidan,K., et al., 2017, PASP, 129, 976
