Navigate
Edit DashboardAnalyze
1D Plots 2D Images Original Inputs Timing Output Warnings1D Plots
2D Images
Table of Original Inputs
All inputs used for the calculation
| Value | |
|---|---|
| Target Mag | 9.625 |
| Saturation Level (electons) | 57600.0 |
| Instrument | niriss |
| Mode | soss |
| Aperture | soss |
| Disperser | gr700xd |
| Subarray | substrip96 |
| Readmode | nisrapid |
| Filter | clear |
| Primary/Secondary | fp/f* |
Timing Info
All the timing info needed for your observation. Overhead calculation assumes 30 minute target acquisition time.
| Value | |
|---|---|
| Transit Duration | 2.905300 |
| Seconds per Frame | 2.214000 |
| Time/Integration incl reset (sec) | 33.210000 |
| APT: Num Groups per Integration | 14.000000 |
| Num Integrations Out of Transit | 228.000000 |
| Num Integrations In Transit | 315.000000 |
| APT: Num Integrations per Occultation | 543.000000 |
| Observing Efficiency (%) | 86.666667 |
| Transit+Baseline, no overhead (hrs) | 5.009175 |
| Number of Transits | 1.000000 |
Warnings
Pay attention to these warnings! If you do not see 'All good' written in each box, reconsider your run.
| Value | |
|---|---|
| Group Number Too Low? | All good |
| Group Number Too High? | All good |
| Non linear? | Partial saturation:\n There are 3 pixels saturated at the end of a ramp. Partial ramps may still be used in some cases. |
| Saturated? | All good |
| % full well high? | All good |
| Num Groups Reset? | All good |
References
When publishing results based on PandExo, please cite:
Batalha, N.E., Mandell, A., Pontoppidan,K., et al., 2017, PASP, 129, 976
